DORANI DORVT15 Dodatkowa instrukcja instalacji

Przeglądaj online lub pobierz pdf Dodatkowa instrukcja instalacji dla Jednostka sterująca DORANI DORVT15. DORANI DORVT15 2 stron. Relay module

SUPPLEMENTARY MODULES INSTALLATION MANUAL

Image 12.1 Connection

If this Module is connected to a

2 Door station System, Port C or

D on the 4 Branch Controller is

used for the input of the Relay

Module

POWER SUPPLY

As Per Monitor

Connections

Images 1.1, 1.2, 2.1

Device & Settings

This device allows a secondary RELAY trigger to be activated without the need for an

additional door station. It also allows for a greater level of security if required as

triggering is done within the home.

Example: Door Station 1 - Call Release 1 = Pedestrian Gate, Release 2 = Driveway Gate

A maximum of 1 Relay Module can be added into the system.

Setting Dip Switches

The dip switch settings on the rear need to be set as per the diagram (Switch 3 = ON)

This enables the Lock release for Door 1 Release 2 on the internal monitors.

Your installation configuration should be done to enable the system to operate in this

manner.

DORANI TOUCH 2 WIRE SERIES

DORVT15: Relay Module

RELAY MODULE

(DORVT09)

(DORVT12)

BUS

As Per Door Station

Images 1.1, 1.2, 2.1

Normally CLOSED

Common

Contacts

Normally OPEN

Ground

SW2 Switch 2 (programming)

BUS

IN OUT

Connections

Relay

12V 450mA Output

SW1 Switch Input 1

Ground

Dip Switch

Setting On Rear