Astro Pneumatic Tool DS2000 Podręcznik - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik dla Narzędzia Astro Pneumatic Tool DS2000. Astro Pneumatic Tool DS2000 6 stron. Pneumatic door skin remover tool

Drukuj stronę

DS2000 OPERATING INSTRUCTIONS

Thank you for purchasing a DS2000 Pneumatic Door Skin Remover Tool from

Astro Pneumatic tool Company. We are confident that you will be very pleased

with this tool. The DS2000 Door Skinner Tool is very straight forward and simple

to operate, however, spending a few minutes to read through these instructions

and tips could make you proficient in the use of the DS2000 much more quickly.

The DS2000 makes short work of opening the crimp of a factory door skin on

either straight or smoothly contoured door edges. It can be used successfully in

areas as short as 3 inches or infinitely longer. The DS2000 employs a new technique

in removing door skins or other auto body panels. Rather than grinding all around

the edge of a damaged skin, the DS2000 simply de-crimps, or folds the crimp of the

skin open. Secondly, applying a prying force upon the unfolded flange with pliers

typically breaks the adhesive (if any) and facilitates easy removal of the damaged skin,

in a very short period of time without damage to the door frame.

Preparation:

There are a few that must be done to make your job successful.

First, consider your personal safety. Jagged edges of steel are very common in the auto body industry, and

your operating hand will be in close proximity to an edge. Use common sense and Always wear approved

safety equipment and clothing when using this product. Wear an appropriate pair of mechanics gloves while

operating the DS2000 tool, to help prevent personal injury.

Operation:

Now you are ready to un-crimp with the DS2000.

We manufacture an accessory hand tool that is made specifically to assist in starting to unfold a small section

of the crimp, and can also be used in tight body lines where the DS2000 cannot be maneuvered.

Alternately, conventional hand tools like a hammer and sharp chisel can be used to accomplish this task.

Once a small section of the flange has been started, hook the tip of the DS2000 un-crimping head on the started

flange, and apply power to the tool. The reciprocal motion of the head quickly and easily unfolds the flange

as you move the tool along the edge of the damaged door skin.

It is important to note that the crimp must be un-folded in one pass.

The un-crimping head of the DS2000 tool is installed at a 20 degree angle to the body of the tool.

The inside edge of the un-crimping head must be kept parallel to the edge of the door. In other words,

the body of the DS2000 must be kept at a 20 degree angle to the door edge. This angle of operation will keep

your hand free of the ragged steel edge as you move the tool. The head can be removed and re-installed

at different angles in 30 degree increments relative to the body of the tool, should you find it necessary.

A secondary handle is also included with your DS2000 to assist in keeping the tool in the proper position.

This handle can be installed in either of two positions vertical or horizontal based on your preference.

Make sure you have the DS2000 connected to good clean shop air at 90 to 120 PSI.

The DS2000 is designed to be very maneuverable. It is capable of negotiating inside curves,

outside curves, concave and convex door edges, and many style lines.

With a little practice, you will experience outstanding results both on the

exterior surfaces of the door and the inside flange, and save LOTS of time as well.

Model:

DS2000