Akw M11 DigiPump Instrukcja instalacji i obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Pompa wodna Akw M11 DigiPump. Akw M11 DigiPump 20 stron.
Drukuj stronę
Flow Direction
Fit Strainer before Sensor
Ensure Sensor and
Strainer are in an easily
accessible location.
Ensure shower water supply
pipework is flushed before
connecting to the shower
sensor via the strainer.
15mm Pipework to Pump Inlet
Flow Direction
Fit Strainer before Sensor
Ensure Sensor(s) and
Strainer(s) are in an easily
accessible location.
Ensure shower water supply
pipework is flushed before
connecting to the shower
sensor via the strainer.
15mm Pipework to Pump Inlet
Note: REMOVE ALL BUILDING RUBBISH FROM TRAY
Otherwise you will be called out again to clear pump blockages!
Electric Shower Installation
Fit one flow sensor to cold
water-feed pipe
Mixer Shower Installation
Fit two Flow Sensors. One to hot
and one to cold water-feed pipes
12V DC
Sensor Cable
230V AC
Supply
DigiPump
12V DC
Sensor Cable
230V AC
Supply
DigiPump
5
From Flow Sensor
or compatable
electric shower.
Cable routing and
separation must
conform to wiring
Regs BS7671.
Ensure all cables
and plumbing
are behind water
resistant surface.
22mm Outlet
Pipework
Cable routing and
separation must
conform to wiring
Regs BS7671.
Ensure all cables
and plumbing
are behind water
resistant surface.
22mm Outlet
Pipework