Coinco vortex Instrukcja instalacji i obsługi
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Zmień maszyny Coinco vortex. Coinco vortex 2 stron. Coin changer, multi-drop bus
Drukuj stronęCOINCO'S VTX1 COIN CHANGER
The Vortex Coin Changer is the result of extensive
research and development in increasing coin capacity.
This greatly simplified unit provides many important
features never before available in any coin changer.
FEATURES
•
MDB (Multi-Drop Bus) Interface
•
Accepts US 5¢, 10¢, 25¢ and $1 coins
•
Dispenses US 5¢, 10¢ and 25¢ coins from self-
loading, high-capacity hoppers
•
Field proven validation technology
•
Tilt-out coin hopper for easy loading
•
Payout sensors ensure coin delivery
•
Programmable coin capacity levels (Float Mode)
•
Flash programmable memory
•
Rugged design withstands harsh environments
UNPACKING
After unpacking the unit, inspect for any possible
shipping damage. If damaged, notify the shipping
company immediately. Keep the carton and packing
material to reuse if you need to transport or ship the
changer in the future. A label indicating the model and
serial number is on the side of the changer. Refer to
these numbers when calling upon your Coinco Service
Center representative for information or service.
INSTALLATION AND OPERATION
(see Figure 1)
1.
Remove the power from the vending machine.
2.
Remove the acceptor from the changer by lifting
the hopper release lever and pulling the acceptor
funnel forward.
3.
Unplug the acceptor harness from the changer.
4.
Mount the changer on the vendor's mounting
screws and tighten.
5.
Install the acceptor by inserting the bottom
acceptor studs into the changer housing guides.
Plug the acceptor harness into the changer. Press
the top of the acceptor into the changer housing.
Slide the hopper release lever down to the locked
position.
Vortex Coin Changer
TM
Installation & Operation Guide
Multi-Drop Bus
6.
7.
8.
9.
10. Test the changer with a variety of coins to ensure proper
Operate the vending machine coin return lever to ensure
proper operation.
Load coins into the hoppers.
Connect the changer MDB harness to the vending
machine and apply power.
NOTE: When power is first applied, the Vortex changer
will cycle all three payout rings twice to establish the
presence of coins.
Pay out a few coins from each hopper.
operation.
Figure 1
Acceptor Funnel
!
!
LED
Hopper
!
Release
Lever
!
!
Front Load
Coins Here
!
Hoppers
Coin Return
Lever
!
Changer
!
Housing
!
Acceptor
!
!
Acceptor
Stud
Model VTX1