Canon L1 Podręcznik procedur instalacji - Strona 41

Przeglądaj online lub pobierz pdf Podręcznik procedur instalacji dla Skaner Canon L1. Canon L1 48 stron.
Również dla Canon L1: Instrukcja obsługi (37 strony)

Drukuj stronę

1. Installation Procedure

Detach the cable cover [I], and remove the six screws

Connect it to the connectors 5804 [I] and 5805 [2] of

[2]; then, detach the rear cover [3].

the saddle drive PCB; then, route the connector cable

through the two cable clamps [3], and fix it in place.

7) If the rubber sheet [l] that comes with the buffer

6) Securely fit the connector cable of the puncher unit

path unit is not already attached, attach it by refer-

to the two connectors on the PCB of the finisher.

ring to the rib [2] found on the right side of the

puncher unit.

Check to be sure that the connector is in firm con-

tact. If the puncher unit malfunctions after installa-

tion, disconnect and then connect the connector and

run a check.

the finisher controller PCB.

8) Mount the finisher's rear cover and the cable cover.

9) Mount the rear small cover of the finisher using a

screw.