Canon Microfilm Scanner 500 Instrukcja obsługi - Strona 20

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Skaner Canon Microfilm Scanner 500. Canon Microfilm Scanner 500 48 stron.

OPERATING PROCEDURES

This section describes procedures for normal operation of the unit:

■ Turning the unit on and off.

■ Adjusting the image on the screen to include focusing, enlarging/

reducing, rotating.

■ Printing the image on the screen.

Follow the procedure below to turn the unit on and off.

1. If you have installed an FS Controller III Autocarrier, turn the

controller on first.

2. On the front of the main unit, locate the power switch on the lower

left corner, then press the I side of the switch to turn the power on.

3. Turn on the power switch of the printer.

After you turn on the power, the Print key indicator on the key-

board lights red and enters the warm-up mode. While the unit is

warming up, you cannot print. After the indicator lights green, the

unit is warmed up and ready to print.

4. To turn the unit off, press the O side of the power switch.

Load the Autocarrier with the film you want to view. For details

about the Autocarrier installation, see the instructions you received

with the Autocarrier.