ASTRO-MED Dash 10 Skrócona instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przyrządy pomiarowe ASTRO-MED Dash 10. ASTRO-MED Dash 10 14 stron.
Drukuj stronę
You are able to change the number of channels that you want to capture.
• Press the soft key below "more".
• Turn the encoder wheel to see which channels/events are enabled or disabled.
Disable all channels except channel 1 by pressing the soft key under "DISABLE",
for each channel you want disabled. The same procedure is used for enabling
channels.
• Press the soft key below "more" to return to the SETUP CAPTURE menu.
• Press the soft key above "RECORD SIZE". Notice that the record size choices
are now either 1 X 768k of 1 X 6144k.
Remember, the first number of the record size indicates the number of channels
or events that are being captured and the second number indicates the amount
memory that is allocated for the data capture per channel or event.
Now, we are going to try a simple capture using the manual trigger.
• Press the [SYS] key. The SYS menu will appear.
• Press the soft key above "SETUP TRIGGER". The SETUP TRIGGER
menu will appear.
SETUP TRIGGER MENU
: MANUAL
: HOST
:
on
: off
: SETUP
: SETUP
: WAVE
: PERIODIC
• Turn the manual trigger to on by pressing the soft key above "MANUAL" until
"on" is displayed.
• Turn the other triggers - Host, Wave, External and Per iodic - to "off" by pressing
the soft key above "HOST", "WAVE", "EXTERNAL" AND "PERIODIC" until
"off" is displayed.
• Press the [ARM] Key. The recorder is now armed and is in the pre-trigger phase.
• Press the [TRIG] key in order to cause the recorder to trigger and complete the
data capture. CAPTURE COMPLETED is displayed when the capture is finished.
Congratulations! You have just completed a data capture. Now play the capture back.
• Press the [MODE] key. The MODE menu will appear.
• Press the soft key belo w "DATA PLAYBACK". The PLAYBACK MODE menu
will appear.
• Press the soft key below "SETUP PLAYBACK". The SETUP
PLAYBACK menu will appear.
• Press the soft key above "SET DEVICE".
• Turn the encoder wheel to select the different output device options.
Select the "display and chart" option.
• Press the soft key below "EXIT".
• Press the soft key above "SET FORMAT".
• Turn the encoder wheel until the "Output format:" is set to chart 2.
The data will now be played ba ck according to the chart format saved under the
CHART 2 soft key in the MODE menu.
• Press the soft key below "EXIT".
• Press the soft key below "EXIT". You should now be back in the
PLAYBACK MODE menu.
• Press the soft key below "RUN PLAYBACK".
: WAVE
: EXTERN
: off
:
off
:
:
: PERIODIC
:
:
off
:
: EXIT
:
10