ASTRO-MED DASH II Skrócona instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przyrządy pomiarowe ASTRO-MED DASH II. ASTRO-MED DASH II 8 stron.
Drukuj stronę•
Push the softkey below [Chrt Spd] to manually change the recorder speed. The current chart speed
will be flashing on the upper line of the display. Use the encoder wheel to change the speed to any
value between 1 and 125. Push the softkeys below [sec] or [min] to change the timebase between
mm/second and mm/minute.
•
Turn the encoder wheel until the "CHART SPEED" reads 5 mm/sec.
•
Press the softkey below "back" to accept this value. The DASH II will return to the Chart Speed
Menu.
•
Press the softkey below [Dlog Spd] to set the data logger speed. For this recording mode, the speed is
set in seconds/line or minutes/line, using the encoder wheel as above. This mode has speeds ranging
from 200msec/line to 999 min/line.
4. SETTING UP CHARTS AND GRIDS
The DASH II has four recording modes. You can select between two discrete grids of 40mm each, two
discrete grids of 50mm each, a single large grid of 100mm with overlapped waveforms or a numerical data
logger. You can also turn the grids on/off, select the major and minor division sizing, position the
waveform anywhere on the grid, suppress or enable the printing of waveforms and vary the waveform trace
thickness.
CHARTS AND DATA LOGGER
•
Press the [MENU] key. The main menu will appear.
MAIN MENU
Chrt
Type
•
Press the softkey below "Chrt Type." You will have the following four options:
2 Grd 40mm - provides two 40mm wide grids, one for each channel.
2 Grd 50mm - provides two 50mm wide grids, one for each channel.
1 Grd 100mm - provides a single 100mm grid with both channels overlapped.
Data Log - Provides a numerical data logger.
To illustrate the differences between chart types, let's choose the 100mm, overlapped chart.
•
Press the softkey below 1 Grd 100mm.
•
Press the [RUN/HALT] key to run the new chart.
CHANGE GRID
the Operations manual for details on changing grids.
STORING SETUPS TO DISK
setup, including: chart type, grid settings, zero and gain settings, speed settings, chart annotation and
trigger settings. Let's demonstrate how setups are saved from the recorder to a floppy disk and loaded
from a floppy disk to the recorder.
•
Press the [MENU] key a second time. The second screen of the main menu will appear.
To select one of the charts or the data logger:
Chrt
Ctrl
The DASH II allows you to modify the grids to suit your needs. Please refer to
A setup file consists of the specific parameters used in a recording
Spd
Syst
Ctrl
Ctrl