Akw 2000 Series Instrukcja instalacji i obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Pomoc w łazience Akw 2000 Series. Akw 2000 Series 8 stron. Seats

Installation

adjust the height of the legs by removing the C-clips, sliding the legs in or out, then replacing

the C-clips (Fig. 2).

Once the seat has been fixed to the wall, perform any fine tuning of the leg. Slide the cover up

the inner part of the leg. Back the nut off the inner leg and then unwind the foot. Move the nut

into position and then wind the foot back in until the nut butts up to the inner leg. Both feet

should be firmly on the floor, i.e. one foot should not be only just touching.

Installation of Seat with Backrest

Mark the desired position of the mounting

Check for cables and pipework before

brackets on the wall ensuring the seat is level.

drilling. Drill the holes with a suitable

Adjust the feet to make finer adjustment.

wall/tile drill bit and insert wall plugs.

Use suitable wall fixings to secure

Ensure all fixings are secure. Re-attach the

the mounting brackets to the wall.

screw cover onto the backrest and ensure

Do not use countersunk screws.

the feet are flat against the floor surface.

General: 01905 823 298