Air Hogs Havoc Stinger Podręcznik użytkownika - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zabawka Air Hogs Havoc Stinger. Air Hogs Havoc Stinger 4 stron. Spin master remote controled toy helicopter user manual
Również dla Air Hogs Havoc Stinger: Instrukcja obsługi (8 strony)
Drukuj stronę
BATTERY INSTALLATION – CONTROLLER/CHARGER
1. Use a Phillips head (Cross-Head) screwdriver to loosen the screws on the battery case anti-clockwise (pic.1).
2. Put 6 AA size batteries in the battery compartment as per the polarity shown inside (pic.2).
3. Tighten the screw in clockwise (pic.3).
STEP ONE
Pull out the cover
and take out the
charging wire.
Things to remember:
1. The helicopter will have 5-6 minutes of flight time after a 20-30 minute charge.
2. Before you recharge the battery, wait 10-15 minutes to let the battery cool down.
1. SET THE BAND ON YOUR CONTROLLER:
To do this, you must check which frequency letter your helicopter is set at.
Turn over the helicopter and you will find a letter (A,B,C) on the bottom.
Set the band selector on your controller to the same letter by moving the horizontal switch.
2. TRIMMING YOUR HELICOPTER:
STEP
Gently push the throttle up to raise your helicopter 1.5 ft to 3.25 ft high off the ground.
ONE
If your helicopter turns CLOCKWISE, continue to push the LEFT side of the trim REPEATEDLY until the turning stops
and the helicopter flies straight.
STEP
TWO
Spiral clockwise
If your helicopter turns COUNTER CLOCKWISE, continue to push the RIGHT side of the trim REPEATEDLY until the turning stops
and the helicopter flies straight.
STEP
THREE
Spiral counter clockwise
3. CHOOSE AN IDEAL FLIGHT ENVIRONMENT
Choose the place which meets the following conditions:
1. Indoor environment with calm air-condition. Beware of the air circulation from the air-conditioner.
2. Space area: It is recommended to have space area over 10 ft (W) x 16.5 ft (L) x 8 ft (H).
3. Safety area: It is highly recommended that there is no electric fan, air-conditioner, reading lamp or other dangerous objects to flying.
HOW TO INSTALL YOUR BATTERIES
pic.1
HOW TO CHARGE YOUR HAVOC STINGER™
STEP TWO
Turn off the power to the
helicopter located on the side
of the helicopter.
ON
CHG
OFF
HOW TO FLY YOUR HAVOC STINGER™
or
Keep turning clockwise
or
Keep turning counter clockwise
pic.2
STEP THREE
Insert the charge plug into
the socket on the side of the
helicopter.
pic.3
STEP FOUR
The green LED will light up when
charging. Once
completed it will
turn OFF. Pull
the plug out from
the side of the
helicopter.
NOTE: Your Havoc Stinger™ loses
its trim EVERY time you turn it off.
So remember these helpful tips to
stabilize it every time!