COLE CL1100 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ploter COLE CL1100. COLE CL1100 16 stron. Cutting plotter

Cole Plotter User Manual

IX. Test Cut and Force Adjustment

Test Cut

Once you have the blade installed and vinyl inserted you may test cut to

check the force of the blade and verify that the plotter is operated

correctly. Press the TEST key to set up the test cut.

Adjustment of blade's force

By pressing the right arrow or left arrow the force of the blade will be

decreased or increased by one level. If the force is too low the cut will not

be deep enough, if it is too high the logo or patterns could be

compromised. Additionally the blade and cutting strip could be damaged.

The blade should normally stick out about 0.5mm or less which is

two-thirds the thickness of the vinyl. While drawing patterns by the plotter

you should first try adjusting the force to be conservatively low.

NOTE：

Always test cut every time you use a new type of vinyl to verify the

cutting force.

http://www.cncoletech.cn/