COLE CL1100 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ploter COLE CL1100. COLE CL1100 16 stron. Cutting plotter

Structure of cutter holder and items of components

Rotate the cutter holder to adjust the length of the blade past the

bottom of the holder making sure that it is not

extended too far, resulting in the blade cutting through

the vinyl backing.

a. Cutter (diameter is 2mm)

b. Cutter holder shell

c. Cutter holder body

d. Cutter-exiting staff

Installation and adjustment

Before installing the cutter, you must carefully clean the cutter

holder body, the cutter and your hands. Even very slight dirt can affect the

rotating sensitivity. Insert the cutter into the cutter holder body with care,

then push the cutter to the bottom with a flexile plastic or rubber, but don't

damage the blade tip.

b. Rotate the shell of the cutter holder and make the out-stretching

length of the blade tip is not larger than the thickness of the vinyl and

adhesive.

Plotter holder

You can use ball-pen to plot with the given plotter holder.

a. Loosen the screw on the holder with a screwdriver

counter-clockwise.

b. Insert a ball-pen and adjust the tip out the proper length.

c. Clockwise fasten the screw.

Installation

a. Turn off the power.

b. Loosen the locking-screw of the cutter-bracket, then put the cutter

holder or plotter holder in the "V" breach and ensure the blade tip or

refill reaches to the plastic pressing-strip. Fasten the locking-screw

clockwise.

c. After turning on the machine, the tip should be raised about 1 to

2mm away from pressing-strip.

http://www.cncoletech.cn/

Cole Plotter User Manual

VI. Loading cutter and pen