Doremi DCP-2K4 Procedura wymiany - Strona 9
Przeglądaj online lub pobierz pdf Procedura wymiany dla Serwer Doremi DCP-2K4. Doremi DCP-2K4 11 stron. Digital cinema servers ssd flash replacement procedure for supermicro x7sbe motherboard fitted units
Drukuj stronę
4 Lid Closing
When the previous upgrade steps are completed, the DCP-2000 lid can be closed by
sliding it from the rear panel to the front side – Make sure there are no wires caught by
the lid.
Tighten the 6 black screws that were removed at the beginning of the procedure, as
presented below:
side screws
Then the unit can be put back into its rack – if any – and connected to power.
CAUTION: In case for any reason the HDD were removed from the unit,
Note: Reconnect all the cables that were disconnected at the beginning of this
procedure.
D2K.DP.000804.DRM
Slide the cover to
the front side of the
chassis
(a)
Figure 10: Lid Closing
Rear panel screws
(a)
Figure 11: Lid Screws
insert them back BEFORE plugging the power cables.
Doremi Cinema LLC Confidential
Rear panel screws
side screws
Page 9
(b)
side
screws
(b)
Version 1.0