Dorma D863 Instrukcje instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Przez blokady Dorma D863. Dorma D863 2 stron.
Drukuj stronę
Install cylinder(s)
For single cylinder deadbolts:
1 Extend the bolt with a screwdriver.
2 Place security shield in hole. Note Do not use security shield in
existing 1 1/2" hole installation.
3 Install the cylinder and trim assembly with the driver bar in the
vertical position.
Trim ring (I.C.Core only)
Security shield
Driver bar
Cylinder and trim assembly
Extend bolt with screw driver here
For double cylinder deadbolts:
1 Extend the bolt with a screw driver.
2 Install each cylinder with its ring and rose.
Place security shield in hole.
Note
Do not use security shield in existing 1 1/2" hole installation.
3 Insert long mounting screws and tighten.
4 Check to make sure the deadbolt operates properly.
5 Insert the faceplate.
Note 1 Mount cylinders on the doors so that the mounting screws
enter from the inside of the door.
2 Both driver bars must fit through the driver bar hole in the
deadbolt assembly.
Caution : Double cylinder locks are operated by key only and may
hinder emergency exit . Check for applicable fire codes and / or life
safety codes before installing double cylinder deadbolt .
www.dorma-usa.com
Both
driver bars
fit through
slotted
driver bar
hole
Long mounting screws
Faceplate
1-800-523-8483
Attach inside trim
1 With the driver bar in the vertical position, slide the thumbturn
assembly over the driver bar.
2 Rotate the thumbturn assembly retracts deadbolt.
3 Secure the thumbturn assembly and the cylinder to the door with
the mounting screws supplied.
4 Test lock with key and thumbturn. Bolt must travel and project fully
into strike preparation without binding.
Driver bar
Install core(s)
1 Put the control key into the core and turn the key 15 degrees
clockwise.
2 Adjust the throw pins if needed, then put the core into the cylinder
housing with the control key.
3 Turn the key 15 degrees counterclockwise and remove the key.
Patents :
Products are protected by one or more of the following
U.S. patents: 5713231. Other patents pending.
Thumbturn assembly
Mounting screw
Throw pins
Cylinder housing
Core
Rotate 15 degrees
Control key
WD-OD002(127)
P/N 50300078
76010391