Dorma ES 100 Podręcznik - Strona 10
Przeglądaj online lub pobierz pdf Podręcznik dla Otwieracz drzwi garażowych Dorma ES 100. Dorma ES 100 14 stron.
Drukuj stronę
__
Fault (floating contact).
Further processing of signal in the eyent of a
malfunction.
Tamper (floating
Further processing
detection.
A\
The brown wire of the cable must be connected
ill
last to PIN 11 (or remove the plug during
installation) as otherwise a short circuit may occur
due to the fact that the 24V power supply from
the back-up battery is still available even when
the mains is disconnected.
A\
The floor keeps should always be kept clean and
ill
free of dirt
9, Familiarisation
Once the commissioning
been performed
instructions
should be handed over to the clienUuser
and they should be properly familiarised
documentation
IO.Further information
£5901100
The
a further
development
control
system.
The commissioning
both control types!
The Rev. 8 control differs from the older control
unit in respect of the following
1.
It has a larger EPROM.
The EPROMs can not be used in the pre-Rev. 8
control
units.
2.
ES 90/100
multipoint
The concealed
connected
The lock type must be programmed
hand terminal.
If the enabled lock type is a concealed
multipoint
the EM 4 is converted
concealed
3.
Adjusting
The force limit can be adjusted
150 N and retrieved
4.
The CP 90 program selector (aka .control
can be also connected.
5.
After connecting
incremental
switched
6.
Night-bank
programs.
This means that the night-bank
applies in all program switch positions.
E_S90_/100__
contact):
of signal in the event of tamper
by
the operator.
and functional
tests have
on the door set, the operating
with both the
and the system.
Revision 8 (Rev. 8) control unit is
of the old ES90/J 00
procedure
is the same for
points:
control,
Rev. 8, with concealed
lock.
rod multipoint
lock can only be
to Rev. 8 controls.
using the
rod
lock, the -Locking
contact"
input on
to a disabling
input tor the
rod multipoint
lock.
the force limit value.
to a value below
using the hand terminal.
the mains power, the
encoder test function
can be
ofi.
funct,on
in all 'AUTOMATIC"
hold-open
~lJ
1
7.
Disable functions
The hand terminal
various disable functions.
8.
In the event of a short circuit
The mains plug merely has to be disconnected
2 to 3 seconds and then re-connected
9.
Expansion modules with Transil diodes on the
soldered side cannot be plugged into the basic
module Rev. 8 due to mechanical
10.
In the case of Rev. 8 basic modules
only one consecutive
number.
This number is located on the plug (I
the hand terminal
11.
Operation without
battery module:
If the door system is operated without
expansion module and without
module, the secondeary trip loop is tested every
four hours (Function
but without the door moving),
rod
panel")
time
@
can be used to implement
for
again.
incompatibility.
(GM), there is
manufacturing
serial
4) to which
is connected.
an expansion
module or backup
an
the backup battery
as per backup battery test
~
DORMA