Dormakaba ORACODE 480 Series Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System otwierania drzwi Dormakaba ORACODE 480 Series. Dormakaba ORACODE 480 Series 10 stron.
Również dla Dormakaba ORACODE 480 Series: Instrukcja instalacji (5 strony)
Drukuj stronę
Key override cylinder
4
If cylinder is not already assembled in the lock, proceed as follow.
1.
Remove 4 screws
2.
Remove back plate
May be required to loosen post to
remove back plate
Adjust lock handing on outside housing assembly
5
Left hand (LH)
Outer cam
Inner cam
Groove at 12 o'clock
6
Assemble tail piece
Click in place
"Wire Ring" opening shall
be align at 12 o'clock.
PK3700 2023-05-01
3.
Install key cylinder
If required, re-tighten post while making
sure not to pinch retaining ring.
Keep retaining ring at 12 o'clock position.
1. Hold inner cam in place, groove always points to 12 o'clock.
2. Rotate outer cam counter clockwise until groove points to 6 o'clock
Hold from rotating
Rotate to change from LH to RH
7
Remove inside cover
Make sure the power cable run
inside cylindrical hub before
mounting the lock on door
panel.
4.
Wire shall not be pinched when
re-installing back plate
5.
Re-assemble back plate using
screws as shown
WARNING
POST ARE MANDATORY FOR
FIRE CERTIFICATION AND
SHALL NEVER BE REMOVED
Assemble outside housing
8
Run cable through door
and under deadbolt
Wire must not
get pinched.
Override
switch
Right hand (RH)
Groove at 6 o'clock
Remove tape
Run cable throught inside
trim 'back plate slot.