Bolton Tools BS-128DR Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła Bolton Tools BS-128DR. Bolton Tools BS-128DR 16 stron. Horizontal and vertical metal cutting band saw

Drukuj stronę

1. Parts List

Burned heavy

Chips-reduce feed rate and/or band speed.

Curly silvery and warm chips-optimum

Feed rate and band speed.

A 1/3 or 1/2 HP motor split phase or capacitor start is recommended for

best economical performance. Counter clockwise is required. Note that

rotation can be reversed by following directions given on terminal or name

plate.

1. Assemble the motor Mounting plate to the head using the long bolt.

Note that the flat side of the plate faces up.

2. Assemble the guard plate to the head using the screw and lock washer

and the carriage bolt. Washer and wing nut are used to secure the

motor mounting plate to the guard plate through the slotted hole in the

guard plate. These components also serve to position and lock the

motor in place or proper speed/belt adjustment.

3. Place the spacer over the long bolt and secure it with the nut.

4. Secure the motor to the motor mounting plate with the four volts and

nuts. Note that the motor shaft is placed through the large opening in

the guard plate and must be parallel with the drive shaft.

5. Assemble the motor pulley, the smaller of the two provided to the motor

shaft. Note the larger diameter must be closest to the motor. Do not

tighten the set screw.

6. Assemble the driven pulley, the larger off the two provided to the

protruding drive shaft. Note the smaller diameter must be closest to the

bearing. Do not tighten the set screw.

7. Place the belt into one of the pulley groove and the other end into the

respective grooves of the second pulley.

8. Line up the belt and both pulleys such that the belt is running parallel in

the pulley grooves.

9. Tighten the set screws of both pulleys in this position.

10. Place the belt into proper pulley combination for proper blade speed.

See material cutting chart.

11. Adjust the position of the motor to obtain approximately 1/2''

ASSEMBLY