Battery Tender Power Tender Plus 24V3A Instrukcje użytkownika

Przeglądaj online lub pobierz pdf Instrukcje użytkownika dla Ładowarka Battery Tender Power Tender Plus 24V3A. Battery Tender Power Tender Plus 24V3A 4 stron. Waterproof vibration resistant (vrw) battery chargers

Drukuj stronę

Power Tender Plus

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS:

important safety and operating instructions for the DELTRAN

BATTERY TENDER® VRW Power Tender Plus Battery Chargers, both

12V6A

and

24V3A

models.

INSTRUCTIONS BEFORE USING THE BATTERY CHARGER.

WARNING AND CAUTION LABEL DEFINITIONS:

WARNING

WARNING indicates a potentially hazardous situation, which, if not

avoided, could result in serious injury or death.

CAUTION

CAUTION indicates a potentially hazardous situation, which, if not

avoided, may result in minor or moderate injury.

CAUTION

CAUTION used without the safety alert symbol indicates a

potentially hazardous situation that if not avoided, may result in

property damage.

GENERAL PRECAUTIONS

CAUTION

WORKING WITH LEAD ACID BATTERIES AND BATTERY CHARGERS: All

lead acid batteries have the potential to emit gasses that may combine into a

combustible or explosive mixture. In many cases, it is possible that lead acid

batteries will emit these gasses during normal discharge and charging

operations. Because of this potential danger, it is important that you follow the

precautions recommended by both the battery and battery charger

manufacturers before using either one.

USING MANUALS: Study all of the battery manufacturer's precautions and

specific recommendations for safe operation such as not removing cell caps

while charging and the recommended rates of charge (charger output current).

Deltran Battery Tender®

WATERPROOF

VIBRATION RESISTANT (VRW)

Battery Chargers

Models

12V6A & 24V3A

This manual contains

CAREFULLY

READ

CAUTION

CHARGER LOCATION: LOCATE the charger as far away from the battery as

is allowed by the length of the output cable harness. NEVER set the charger

above the battery. NEVER set the charger on a surface constructed from

combustible material.

CHARGER VOLTAGE COMPATIBILITY: NEVER use a battery charger

unless the battery voltage matches the output voltage rating of the charger.

For example, do not use a 12-volt charger with a 6-volt battery and vice-versa.

EXCESSIVE MOISTURE: The charger body and power cords are fully

waterproof. However, do not expose the AC and DC electrical connections at

the ends of the power cords to rain or snow.

CHARGER ATTACHMENTS:

recommended or sold by Deltran or its affiliates. To do otherwise may result in

the risk of electric shock, fire, or possibly some other unforeseen potential

personal injury situations.

HANDLING POWER CORDS: When handling electric power cords, always

THESE

pull by the plug rather than by the cord. This will reduce the risk of damage to

both the plug and cord, and it will minimize the likelihood of electric shock

resulting from that damage.

LOCATION OF POWER CORDS: Make sure all electric power cords are

located so that they cannot be stepped on, tripped over, or otherwise

subjected to damage or stress.

MONITORING SEALED & NON-SEALED BATTERIES: When leaving a

battery charger connected to either a sealed (AGM or GEL) or non-sealed

(flooded battery) for extended periods of time (weeks, months, etc.),

periodically check the battery to see if it is unusually warm. This is an

indication that the battery may have a weak cell and that it could go into a

thermal runaway condition. If the battery releases an excessive amount of gas

or if the battery gets hotter than 130°F (55°C) during charging, disconnect the

charger and allow the battery to cool. Overheating may result in plate

distortion, internal shorting, drying out or other damage. For flooded batteries,

also check individual cell fluid levels against manufacturer's recommendations

for safe operation.

WARNING

ELECTRIC SPARK & OPEN FLAME: NEVER smoke or allow a source of

electric spark or open flame in the vicinity of the battery or engine. (For

example: Don't charge the battery next to a gas water heater.)

VENTILATION: Do not operate the charger where ventilation is restricted.

The intent here is to allow sufficient airflow to minimize and dissipate the heat

generated by the charger and to diffuse the gasses that may be emitted by the

battery.

CHARGER MAINTENANCE: NEVER disassemble the charger or attempt to

do internal repairs. Take it to a qualified service technician. Assembling the

charger incorrectly may result in the risk of electric shock or create a fire

hazard.

Do not use attachments that are not