Dot Origin VTAP100 Instrukcja instalacji - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Jednostka sterująca Dot Origin VTAP100. Dot Origin VTAP100 17 stron. Desktop usb reader
Również dla Dot Origin VTAP100: Instrukcja instalacji (13 strony), Instrukcja instalacji (16 strony)
Drukuj stronę5 Hardware lock to disable USB mass storage device
You can lock the VTAP100 so that its firmware and configuration cannot be changed. You can
either do this in software, or simply disable the mass storage device in hardware., which is
described in the VTAP Configuration Guide
A software lock prevents changes but leaves some files visible. A hardware lock means that
the VTAP100 will no longer be detected as a USB mass storage device. (It will still behave as
an HID keyboard device and, if enabled, the virtual COM port will behave as a composite USB
device consisting of HID keyboard and USB virtual COM port.)
You can use a hardware lock provided the jumper labelled LOCK (close to the
MicroUSB connector) remains accessible on a VTAP100 OEM module.
Connect a jumper across LOCK on the PCB to lock the device, preventing firmware or
configuration changes via the mass storage device. (It may still be possible to update the
firmware or configuration via the command interfaces of the virtual COM port or serial ports,
if they are enabled.)
When you start the VTAP100, the presence of this jumper means the connected PC will not
detect a USB mass storage device. The VTAP100 will only be detected by the PC as a
keyboard (or keyboard and virtual COM port).
At any time you can remove the jumper across LOCK. When you restart the VTAP100, it will
be detected as a USB mass storage device and you will be able to make firmware or
configuration changes again.
VTAP100 OEM MODULE
INSTALLATION GUIDE
Figure 5-1 Jumper positions on VTAP100 PCB v4a hardware
© DOT ORIGIN
VTAP MOBILE WALLET READERS
PAGE 11