Baumer 09 Series Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria Baumer 09 Series. Baumer 09 Series 11 stron. Ultrasonic sensors rs-232

Drukuj stronę

1. General Information

Load factory

settings

Set measuring

mode

Set output

format of

permanent

periodical data

output

Set sensor

sensitivity

(Sensors with

beam

columnator)

Set number of

averagings

Temperature

compensation

on, off

Teach-in of Sdc X

Bedienungsanleitung_Series09-US_RS232_V1_e.doc

26.03.2013 14:43:00/tof

Configuration

{0D}

{0Dßß}

{0AX}

{0AXßß}

{0FX}

{0FXßß}

{0BX}

{0BXßß}

{0CX}

{0CXßß}

{0Gx}

{0Gxßß}

{0X}

{0XXßß}

The Sensor is configured with its

factory settings.

See chapter „Factory

configurations"

A: absolute measurement in 0.1mm

steps

B: relative measurement within the

Teach-range 0...4096

See chapter „Commands explained

in detail"

A: ASCII

B: Binary

See chapter „Commands explained

in detail"

A: Highest sensitivity

Measuring into test tubes

Measuring range: 3...150 mm

B: Second highest sensitivity

Measuring into plates size 96 with

big hole diameter

Measuring range: 3...110 mm

C: Second lowest sensitivity

Measuring into plates size 96 with

small hole diameter

Measuring range: 3...70 mm

D: Lowest sensitivity

Measuring into plates size 384

Measuring range 3...30 mm

See chapter „Commands explained

in detail"

A: not averaged

B: 2

C: 4

D: 8

E: 16

F: 32

G: 64

See chapter „Commands explained

in detail"

0: Temperature compensation off

1: Temperature compensation on

See chapter „Commands explained

in detail"

Reads and stores close limit Sdc

A: Teach-in successful

B: No object within measuring

range → basic setting for the

sensitivity the currently set

sensitivity level

6/11

Baumer Electric AG

Frauenfeld, Switzerland