Colzer CFT4.0D Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Osuszacz powietrza Colzer CFT4.0D. Colzer CFT4.0D 17 stron.

inlet air which is similar to the room temperature. However, if the timer function is being

set or has been activated, the small font digital number will turn to display the timer

setting value or time remaining.

Running Icon：Running icon flickers typically because the compressor has not kicked in. It

usually happens 1) when the dehumidifier is under the 3-minute compressor delay status; 2)

when the dehumidifier is programmed to delay-start (AUTO ON TIMER).

Wet Controller Icon: Wet Controller Icon flickers when the room humidity level (inlet

humidity reading) is 3% lower than the set humidity.

1) When you see the "wet controller" icon illuminating while setting up, it typically means

the set humidity level is not 3% lower than the inlet humidity reading. Please make sure

the set humidity value is at least 3% (10% recommended) lower than the inlet humidity

reading.

2) In Humidistat Mode, if you see "wet controller" icon illuminating after running the

dehumidifier for a while, it means the dehumidifier has got the room humidity down to

the set point and the dehumidifier enters into standby mode. When the room humidity

level raises up to 3% higher than the set humidity, the dehumidifier will automatically

restart to dehumidify. That is to say, the dehumidifier will automatically stop or restart to

maintain the room humidity level within a range of ±3% of the set point.

For example, if the set humidity is 50%, when the inlet humidity level the dehumidifier detects is

47%, 3% lower than the set humidity, the dehumidifier will automatically stop and enter into "wet

controller" mode. When the inlet humidity level the dehumidifier detects raises to 53%, 3% higher

than the set humidity, it will automatically restart.

Defrosting Icon: The dehumidifier begins to defrost when the frost has accumulated on the

interior of the dehumidifier. When the dehumidifier is defrosting, the fan is running, but

the compressor is not, the defrost icon is flashing. The dehumidifying function will cease

until the frost has melted. When defrosting is complete, the defrosting Icon will disappear

and the dehumidifier begins to dehumidify again automatically.

Note: The frequent defrost process indicates that the room temperature is too cold.

Therefore, if the room temperature is lower than 60°F, please consider adding heat to

promote proper drying.

Fan Icon: The fan icon illuminates when the fan is running.

Water Droplets Icon: The water droplets icon illuminates when the compressor kicks

in, which means the dehumidifier is dehumidifying.

due to the 3-minutes delay system, this icon flickers.

When the compressor delays to start