Baumer CombiTemp TFRN Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria Baumer CombiTemp TFRN. Baumer CombiTemp TFRN 12 stron. Temperature sensor
Drukuj stronę
English page 1 ... 7
Mounting for TFRN
The CombiTemp™ TFRN can be mounted in several different ways.
1.
Sensor tube without connection
Baumer offers compression glands fitting Ø6 and Ø8 mm sensor diameter. This type of mounting is normally
used for mounting a sensor direct into a non-pressurized application. If pressurized, ensure that the connec-
tion is tightened correctly, so no leakage occur.
A duct channel mounting flange for 8 mm sensor is also available.
All threaded connections can be mounted directly into the application without thermowell, however often a thermowell
is required to enable the user to take out the sensor for e.g. calibration without opening the system.
2.
Sensor with male threaded process connection G 1/2 A
This is suitable in a Baumer thermowell type ZPT4. The process connections available for ZPT4 are
R 1/2, G 1/2 A, G 3/4 A, M20 or with hygienic ISO 2852 clamp DN 38.
3.
Sensor with male threaded process connection G 3/4 A and G 1 A and sensors with G 1/2 or G 3/4 female
thread can be supplied with a special thermowell. Please contact Baumer.
Mount the gland/pocket into the application and install the sensor after the gland/pocket is fixed to the application.
This will ensure that the cable is not twisted during mounting.
Baumer recommends to use a thermal compound filled into the thermowell to ensure best possible heat transfer
between the pocket and the CombiTemp TFRN. Baumer offers a 6 gram bag Thermal compound, type ZPX1-001
www.baumer.com
Temperature sensor
CombiTemp TFRN/TFRH
Operating instructions
Operating Instructions: 11163172 06 EN
Page 5 / 12