Com-Power AC-220 Podręcznik - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik dla Antena Com-Power AC-220. Com-Power AC-220 13 stron. Combilog antenna 30 - 2000 mhz

Setup Procedure

2.0 Introduction

2.1.1 Connecting

2.1.2 Antenna setup for receiving signals

2.1.3 Antenna setup for transmitting signals

Distributed by: Reliant EMC LLC, +1 408 916‐5750, [email protected], www.reliantemc.com

This section explains the following:

Introduction

Setup

This section describes antenna setup and mounting for EMI measurement.

The model AC-220 Combilog antenna has an 'N' type female I/O connector for

connection to measuring or source instrumentation.

The model AC-220 antenna can be used to measure EMI from an equipment

under test (EUT). The antenna is mounted on either an antenna mast (model

AM-400) or an antenna tripod. The antenna has a universal mount (included) for

mounting on a tripod (AT-100) or other standard tripod. A cable is used to con-

nect the antenna to the measuring instrument. If a long cable is used, cable loss

must be measured and used in calculating the field strength.

The model AC-220 antenna can be used to transmit signals. The antenna is

mounted on either on an antenna mast (such Model AM-400 antenna mast ) or

antenna tripod. To transmit signals, the antenna is connected to a signal generator

and power amplifier. The Model AC-220 Combilog antenna can transmit up to

500 Watts continuous power. The field generated by the antenna can be measured

by using field strength meter.

2-1

AC-220 Combilog Antenna