Com-Power AH-826 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Antena Com-Power AH-826. Com-Power AH-826 10 stron. Horn antenna

Page 8 of 10

INSTRUCTION MANUAL

Horn Antenna (AH‐826)

6.0 Setting up and using the antenna

6.1 Connecting

The model AH‐826 horn antenna has a type SMA female connector of signal output or input.

It can handle up to 5 Watts CW signal. These connectors are delicate and should be handled

with care. Do not over tighten or use excessive force when making connections.

6.2 Antenna setup for receiving signals

The model AH‐826 must be connected to the receiver / spectrum analyzer with high

frequency, low loss cables. The loss must be measured and used in calculating the field

strength.

6.3 Antenna setup for transmitting signals

When the AH‐826 antenna is used for transmitting signals, the antenna is connected to a

microwave signal generator and a power amplifier. The model AH‐826 antenna can transmit

up to 5 Watts of continuous power. The field generated by the antenna can be measured by

using a field strength meter / probe or another horn antenna.

6.4 Test location

The Horn Antenna must be mounted and placed in area away from other conductive objects

or materials when in use. Large conductive building, structures and electrical cables, can

reflect and reradiate the emissions of EUT, causing errors in the test data. In addition, care

should be taken to keep measuring instruments and test personnel away from the test area

to avoid interference to the test, as well exposure of test personnel to high electro‐magnetic

fields.

19121 El Toro Road Lake Forest, CA 92676 ● (949) 459‐9600● fax (949) 459‐9604 ● com‐power.com

REV102913