Dahua F Series Skrócona instrukcja obsługi - Strona 11

Dahua Panoramic + PTZ Network Camera Quick Start Guide

Connect the device cable to the external cable according to the use

requirements, and use insulated rubber tape to twist the cable connection

well to make it waterproof.

Note

Please be aware that the bending radius needs to be no less than 30mm

when connecting to optical fiber.

Install waterproof connector

Keep the convex groove outward and install the rubber ring into

the network port, and keep the smaller hole of the rubber ring

outward and install the fixing rubber ring into the main body of the

waterproof connector.

After pulling the network cable without crystal head through main

body of waterproof connector, fixing rubber ring and waterproof

fastening cover, make the crystal connector of network cable and

then insert it into the network cable.

Put the main body of waterproof connector on the network port and

rotate it clockwise to lock the network port and waterproof

connector firmly.

Put the waterproof fastening cover on the main body of waterproof

connector and rotate it clockwise to lock the waterproof connector

and waterproof fastening cover firmly.

Stuff the cable into the installation bracket after connection.

Step 7 Fix the device on the installation bracket.

Put the device into the adapter block and tighten it firmly by anti-drop

screws.

Adjust the monitoring angle according to the use requirement.

Use the locking screws to fix the device.

Figure 3-3