Asus AAM6020BI-T4 Podręcznik użytkownika - Strona 29

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Router sieciowy Asus AAM6020BI-T4. Asus AAM6020BI-T4 38 stron. Cpe (customer premises equipment) adsl 4 port router

Drukuj stronę

AAM6030BI User Manual

Figure 16-2 (IGMP SNOOPING)

4.6.8

Static Routing

If the CPE is connected to more than one network, you may need to set up a static route between them. A

static route is a pre-defined pathway that network information must travel to reach a specific host or

network. You can use static routing to allow different IP domain users to access the Internet through the

CPE.

The New Destination IP is the address of the remote LAN network or host to which you want to assign a

static route. Enter the IP address of the host for which you wish to create a static route here. For a standard

Class C IP domain, the network address is the first three fields of the New Destination IP, while the last

field should be 0. The Subnet Mask identifies which portion of an IP address is the network portion, and

which portion is the host portion. For a full Class C Subnet, the Subnet Mask is 255.255.255.0. The CPE

IP address should be the IP address of the CPE device that allows for contact between the CPE and the

remote network or host. The Hop Count determines the maximum number of steps between network nodes

that data packets will travel. A node is any device on the network (such as a router or switch)

To enable Static Routing, from the Home screen, click Advanced and under Advanced, select Static

Routing. Figure 17 illustrates a typical Static Route.