Asus AAM6030BI Podręcznik użytkownika - Strona 27

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Router sieciowy Asus AAM6030BI. Asus AAM6030BI 38 stron. Cpe (customer premises equipment) adsl 4 port router

Drukuj stronę

AAM6030BI User Manual

or deny) is performed. The user should note that the bridge filter will only examined frames from interfaces

which are part of the bridge itself. Twenty filter rules are supported with bridge filtering. To enable Bridge

Filters, from the Home screen, click Advanced and under Advanced, select Bridge Filters. Figure 15

illustrates a typical Bridge filter configuration.

The User Interface for Bridge Filter allows the user to add/edit/delete, as well as, enables the filter rules. To

add rules, simply define the source MAC address, destination MAC address and frame type with desired

filtering type (i.e. allow/deny), and press the "Add" button. The MAC address must be in a xx-xx-xx-xx-

xx-xx format, with 00-00-00-00-00-00 as "don't care". Blanks can be used in the MAC address space, and

would be considered also as "don't care".

To edit/modify an existing filter rule, select the desired rule created previously from "Add" in the "Edit"

select box. The selected filter rule will appear on top section, as with the "Add" filter rule. Make the

desired change to the MAC address, frame type and/or access type, and press "Apply".

To delete filter rule(s), select the filter rule entry to delete in the "Delete" selection box. Note that multiple

deletions are possible. Once all the desired filter rule(s) is/are selected for deletion, press the "Apply"

button. The "Select All" select box can also be used to delete the entire filter rule. It provides a quick

method of selecting all filter rules for deletion.

The "Enable Bridge Filters" button allow the user to enable or disable bridge filtering. It can be set/unset

during any add/edit/delete operation. It can also be set/unset independently by just pressing the "Apply"

button.

Figure 15 (Bridge Filters)

Note: The bridge filter table contains 3 hidden rules. These rules are entered automatically by the system to

ensure the user does not "lock" them out of the system. The first rule allows any and all ARP frames

through the system. The second rule allows all IPv4 frames with the destination MAC address of the bridge

to go through. The third rule allows all IPv4 frames with the source MAC address of the bridge to go

through.

Note: On a windows based machine, to find a MAC address, ad a dos prompt type ipconfig /all.

The apply button will temporarily save this connection. To make the change permanent you need to click

on Tools (at the top of the page) and select System Commands. At the system commands page, click on

Save All.