Doughpro DP2000ICEC Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Doughpro DP2000ICEC. Doughpro DP2000ICEC 18 stron. Dual heat tortilla press

Symptom

Heater Platen overheating

Dough not having same thickness

across the press dough.

DOUGHPRO

DP2000 Trouble Shooting Guide

Probable Cause

If the Relay (depending the year of

the model) on the coil side are

receiving 12vdc indicates the

Controller is functioning properly. On

the switching side of the relay, is

there 120 vac going to the heater in

question . If there is no voltage on

the to the switching side of the relay

to the heaters, the Relay is not

working properly. It has been seen

on remote cases, the Sensor (2M

ohm) can give a false reading as well.

To adjust upper platen for level press Underneath the arm resting on the

Action to be Taken

Replace Relay If the Controller's heat-

on LED is not lit indicating the

controller is working properly. If this is

not the issue, replace sensor.

Upper Platen Shroud you will find 4,

stacked hex bolts sitting over the upper

platen attach to the arm. The top bolts

are called locking bolts. The 4 larger

Hex Bolts below are Adjustment Bolts.

Break free the 4 Locking blts. With a

open end wrench adjust the A. bolts

(1/8 turn at a time where needed and

test with dough. After satisfied,

tighten the Locking bolts making sure

not to move the larger Adustment

Bolts.