Douglas D-Pro Max Series Instrukcja montażu i instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja montażu i instrukcja obsługi dla Akcesoria Douglas D-Pro Max Series. Douglas D-Pro Max Series 8 stron. Adjustable basketball system

Drukuj stronę

*BECAUSE OF THE SIZE AND WEIGHT OF THE SYSTEM, A MINIMUM OF

THREE ADULTS ARE REQUIRED FOR THE FOLLOWING STEPS*

STEP1

Slide a 16mm Thick Washer (U3) over each of the J-Bolts (U2) as shown in FIGURE 1A.

Remove the Padding from Main Post (A). Place the Main Post (A) over the J-Bolts. Slide a

16mm Thick Washer (U3), a Lock washer 16mm (U6) and thread a 16mm Hex Nut (U4) to each

J-bolt. Tighten the Nuts only a few turns onto the J-Bolts as shown in FIGURE 1B.

If the Main Post (A) is not exactly vertical, adjust the 16mm J-Bolt Hex Nuts (U4) located under

the Post base. Tighten all of the Hex Nuts (U4) Above Post base when Main Post (A) is vertical.

NOTE: Face the Main Post (A) with Actuator Bracket facing away from playing court (as shown in FIGURE

1C).

FIGURE 1A

STEP2

A. Slide the Main Extension Arm( F ) over the top of the Main Post (A)

and attach to the lower pivot tube with a M18 x 12.6" Hex Bolt (#5),

two M18 Flat Washers(#11), two Nylon Washers M18 (#1) and one

Lock nut M18 (#14).

Do not over tighten this bolt and nut.

Note: make sure Nylon washers locate between Main Extension Arm (F) and Post (A).

The Nylon washers may be factory-assembled.

B. Install stop pin through designated hole and secure with ring

WARNING

FIGURE 1B

Nylon washer #1 may

be factory installed

Playing Court

FIGURE 1C

14 11

Rubber pad face up

Back