Baumer HUBNER BERLIN HOG 10 Instrukcja montażu i obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja montażu i obsługi dla Konwerter mediów Baumer HUBNER BERLIN HOG 10. Baumer HUBNER BERLIN HOG 10 40 stron. Incremental encoder with connecting cable ölfle
Również dla Baumer HUBNER BERLIN HOG 10: Instrukcja instalacji i obsługi (36 strony), Instrukcja instalacji i obsługi (40 strony), Instrukcja montażu i obsługi (40 strony), Instrukcja instalacji i obsługi (40 strony), Instrukcja montażu i obsługi (40 strony), Instrukcja montażu i obsługi (32 strony), Instrukcja montażu i obsługi (36 strony), Instrukcja montażu i obsługi (36 strony), Instrukcja montażu i obsługi (28 strony)

Drukuj stronę
Baumer HUBNER BERLIN HOG 10 Instrukcja montażu i obsługi
1
General notes
1.1
Symbol guide:
Danger
Warnings of possible danger
General information for attention
Informations to ensure correct device operation
i
Information
Recommendation for device handling
1.2
The incremental encoder HOG 11 (HOG 11 G) is an opto electro nic precision measurement
device which must be handled with care by skilled personnel only.
1.3
The expected service life of the device depends on the ball bearings, which are equipped with a
permanent lubrication.
1.4
Option earthing: The expected service life of the carbon brushes depends on the electrical cur-
rent and is usually consistent with the service life of the ball bearings.
1.5
The storage temperature range of the device is between -15 °C and +70 °C.
1.6
The operating temperature range of the device is between -40 °C and +100 °C
(>3072 pulses per revolution: -25...+100 °C, option heating: -50...+100 °C), restricted in
potentially explosive environments, see section 2, measured at the housing.
1.7
EU Declaration of Conformity meeting to the European Directives.
1.8
The device is UL approved (not applicable for operation in potentially explosive atmospheres).
1.9
We grant a 2-year warranty in accordance with the regulations of the ZVEI (Central Association
of the German Electrical Industry).
1.10
The device may be only opened as described in this instruction. Repair or maintenance work
that requires opening the device completely must be carried out by the manufacturer. Alterations
of the device are not permitted.
1.11
In the event of queries or subsequent deliveries, the data on the device type label must be
quoted, especially the type designation and the serial number.
1.12
Device components are to be disposed of according to the regulations prevailing in the re-
spective country.
i
Warning!
Damaging the seal
MB072T2 - 11070661
on the device invalidates warranty.
Baumer_HOG11-HOG11G-T2_II_DE-EN (17A2)
1
General notes
2