Douglas Dynamics 77850 Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Douglas Dynamics 77850. Douglas Dynamics 77850 17 stron. Snowplow

2. Reposition the hoses as shown.

3. Fully extend the lift cylinder. Gently remove most

of the slack in the hoses between the hydraulic

unit and the hose clamps. Do not stretch the

hoses.

4. Retighten hose clamps and re‑install the original

hose wrap between the hose clamps and hydraulic

unit.

Lit. No. 52238, Rev. 05

INSTALLATION INSTRUCTIONS

HYDRAULIC HOSES TO WING RAMS

Assembling a hose to the incorrect wing ram

port can result in permanent damage to the ram.

Do not use thread sealant/tape on hoses and fittings.

This could damage the product.

1. Attach the hoses labeled A, B, C, and D at the

hydraulic unit to the corresponding labeled fittings

on the wing rams.

A B

DS Wing Ram

2. Using pliers to hold the hose end in position,

tighten all hose fittings 1/8 to 1/4 turn past finger

tight.

3. If the factory‑installed hose wrap was previously

removed, reinstall the hose wrap on the

repositioned hoses.

4. Install additional hose wrap as needed on the

portion of the hoses extending beyond the hose

clamps, maintaining the hose positioning as

shown.

CAUTION

C D

PS Wing Ram

July 15, 2020