Douglas Dynamics SnowEx HDV 77775 Instrukcja instalacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Douglas Dynamics SnowEx HDV 77775. Douglas Dynamics SnowEx HDV 77775 16 stron. Snowplow
Drukuj stronęT‑FRAME TO BLADE ASSEMBLY
1. Remove the blade wings from the crate. Remove
the four shipping straps, then replace the cutting
edge hardware.
2. Align the hinges of each wing. Position the
T‑frame assembly between the blade wings so
that the holes in the T‑frame are aligned with the
holes in wing hinges.
3. Insert the pivot pin from top to bottom through all
hinges as shown.
Lit. No. 52592, Rev. 04
INSTALLATION INSTRUCTIONS
1" x 4-3/4"
Clevis Pin
4. Move the snowplow into a normal operating
position.
5. Remove the protective packaging from the angle
rams.
6. Align the holes in the rod end of the angle ram
with the corresponding holes on the back of the
blade.
7.
Install a 1" x 4‑3/4" clevis pin (from the shipping
bracket) from the top down to attach each rod.
Secure the clevis pins with 1/4" x 1‑1/2" cotter pins
from the parts bag.
Pivot Pin
1" x 4-3/4"
Clevis Pin
1/4" x 1-1/2"
Cotter Pins
7
July 15, 2020