Baumer PMG10P Instrukcja obsługi - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Konwerter mediów Baumer PMG10P. Baumer PMG10P 36 stron. Absolute encoder
Również dla Baumer PMG10P: Instrukcja montażu i obsługi (32 strony), Instrukcja montażu i obsługi (36 strony), Instrukcja montażu i obsługi (32 strony), Instrukcja obsługi (44 strony), Instrukcja obsługi (44 strony), Instrukcja obsługi (40 strony), Instrukcja obsługi (40 strony), Instrukcja obsługi (40 strony)

Baumer Hübner

g) Fasten the coupling onto the shaft of the drive at a torque of 1.3 ±10 % Nm.

Observe the remarks in the data sheet and the coupling assembly instructions.

Maximum permitted tolerances for mounting errors when using the

5.3

Baumer Hübner K 35 spring washer

NOTICE

Damage to the encoder ball bearings.

Hard impacts of the drive shaft imposed on coupling parts may damage the ball bearings.

a) Prevent any hard impacts of the drive shaft on coupling parts.

Instruction:

a) Mount the drive with small angular error and parallel offset.

b) Note the following allowable mounting errors:

The figure shows the device with EURO flange B10, the same maximum permissible mounting

errors must be observed for the device with housing foot B3.

Permitted parallel misalignment

* With insulated plastic hub

Ill. 7: Permissible mounting errors (dimensions in mm)

5.4

Notes when using a claw coupling (e.g. ROTEX®)

NOTICE

Damage to the rotary encoder due to incorrect mounting of the claw coupling.

Blocking of the two coupling halves (coupling claws lie face to face) can damage the rotary en-

coder.

a) Make sure that the coupling claws do not block.

b) Make sure that there is no direct axial stop on the device shaft.

V1 | PMG10 & PMG10P EtherCAT

Permitted angle error

Operating Manual

Installation

Permissible axial movement

±0.7 (±0.3*)