Baumer CleverLevel LBFH Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Baumer CleverLevel LBFH. Baumer CleverLevel LBFH 48 stron. Point level detection – hygienic/industrial level measurement

Baumer CleverLevel LBFH Instrukcja obsługi
CleverLevel
Point level detection – hygienic/industrial
7.

Electrical connection in explosion hazard areas

Depending on the variant, the LBFH/I is approved for most explosion hazard areas.
DANGER
Risk of fatal accident due to a wrongly connected sensor
In explosive gas atmospheres of zone 0 or 1, use Baumer isolation barriers or Zener barriers.
f
„
In explosive dust atmospheres, use insulated cable to IP67.
f
„
Allow only persons trained in explosion protection to perform the installation.
f
„
Never use FlexProgrammer or IO-Link Master configuration tools in explosion hazard areas.
f
„
7.1 Explosive gas atmospheres zone 0 and 1
The LBFH/I can be used in explosion hazard areas of zone 0 or zone 1. Sensors can use Baumer isolation
barriers which are easy to install or use Zener barriers.
Approval for LBFx.xx.xxx.xxxxxx.x.4xxx.x: ATEX II 1G Ex ia IIC T4 Ga
and ATEX II 1D Ex ta IIIC T100 °C Da (TÜV 17 ATEX 188894 X)
LBFx.xx.xxx.xxxxxx.x.4xxx.x and additional
dust atmospheres:
Use insulated cable to IP67.
f
„
Secure cables with external strain relief at a
f
„
distance 5 centimeters from the sensor.
All LBFH/I in zone 0 and zone 1
Use PROFSI3-B25100-ALG-LS isolation
f
„
barriers for the connection.
– or –
Use Zener barriers.
Comply with the following temperatures,
f
„
connection values and circuit diagram.
DANGER
Risk of fatal accident due to failing communication with the sensor
IO-Link communication is not possible when a barrier is installed.
Do not use IO-Link communication together with a barrier.
f
„
8 / 48

Level measurement

LBFH/I
®
1
3
4/2
Operating Instructions
ATEX II 1G Ex ia IIC T4 Ga
Highest values for se-
lection of barriers
Internal capacitance
Internal inductance
Temperature class
Protection class for
cable accessories
+
SW1/SW2
Ui: 30 V DC
Ii: 100 mA
Pi: 0,75 W
Ci: 63 nF
Li: 617 µH
T1...T4:
–40 < Tamb < 85 °C
IP67
Function
M12-A
4-pin
+ Vs
1
GND (0V) 3
SW1/SW2 4/2
www.baumer.com