Baumer TER8 Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Baumer TER8. Baumer TER8 28 stron. Temperature measurement, front-flush and low-invasive resistance thermometers
Drukuj stronę
Table of contents
1.
Safety .......................................................... 3
2.
Construction and function ........................... 3
3.
Symbols ...................................................... 4
4.
Transport and storage ................................. 4
5.
Mounting ..................................................... 4
6.
Electrical connection ................................... 6
1.
Safety
Intended use
The sensor measures temperatures of liquids and
solids within the range of -40 ... 135 °C.
The sensor must only be used for media against
which the housing material and sensor tip are
resistant.
Staff qualification
Only use staff who are trained for the activities
described. This applies in particular to assembly,
installation, configuration and troubleshooting.
Make sure that the staff have read and understood
these instructions.
2.
Construction and function
1
2
www.baumer.com
Temperature measurement
TER8
Front-flush and low-invasive resistance
thermometers
7.
8.
9.
10.
11.
12.
Technical condition
Only use sensor in perfect technical condition.
Only use Baumer accessories.
Baumer will accept no liability for other
manufacturers' accessories.
Risk of burns from hot media
During operation the sensor housing may warm
up to over 50 ºC. When working with hot media
provide protection against burns.
1
3
2
3
The TER8 is a compact temperature sensor based
on RTD technology. With its PEEK sensor tip the
sensor can be used in hygienic processes. The
output signal is a Pt100 signal or with a built-in
temperature transmitter a 4 ... 20 mA signal.
Operating Instructions
Configuration ............................................... 6
Troubleshooting ........................................... 7
Cleaning, maintenance and repair............... 7
Disposal ...................................................... 7
Accessories ................................................. 7
Technical data ............................................. 8
Sensor PEEK tip
Process connection
Electrical connection M12-A
3 / 28