Amphenol Temposonics MH Series Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria Amphenol Temposonics MH Series. Amphenol Temposonics MH Series 18 stron. Analogue/pwm tester
Również dla Amphenol Temposonics MH Series: Podręcznik użytkownika (12 strony)

Drukuj stronę

Temposonics

MH Analog

Operating Manual

2. Temposonics

MH series analog

Temposonics

MH series sensors are designed for hydraulic cylinders. With the analog output configuration they are qualified to operate on

electronic controls of mobile machines. Sensors with different analog output signals (mA/ VDC) are suitable for applications on vehicles.

3. Safety and operating instructions

Before starting the sensors operation, please, read this documentation carefully and follow the safety instructions.

This technical documentation provides information on the mechanical installation of Temposonics

service technicians who are familiar with sensor projecting and handling.

Intended use

Temposonics

The sensors are built acc. to actual electrical engineering standards and meet the state of technology. EMC requirements for

interference emission and immunity for mobile machines and vehicles fulfilled. Technical rules and notes for installation and

operation in vehicle electronics to keep in mind.

The sensors are intended for measuring tasks in the field of mobile hydraulics. They are considered as accessories and must be connected to

suitable evaluation electronics, e.g. a PLC, IPC, indicator or another type of electronic control unit.As a prerequisite to ensure perfect and safe

sensor operation, correct transport, storage, mounting, commissioning and careful operation are mandatory. The sensors may be used only in

safe condition. To maintain this condition and ensure safe operation, installation, connection and service work may be performed only by quali-

fied and authorized personnel.

Information related to danger

Information related to danger is intended for your personal safety and for the safety of the described product or connected equipment against

damage.

Installation and operation

If failure or functional disorder of the sensors cause danger for persons or imply a hazard of damage to operating facilities, additional safety

measures such as plausibility checks, limit switches, EMERGENCY OFF systems, protective devices, etc. must be provided to prevent it. In the

event of trouble, shut down the sensor and protect it against unauthorized operation.

To maintain the sensor operability, it is indispensable to observe the following information:

- Protect the sensor against mechanical damage during installation and operation.

- Don't open or dismantle the sensor.

- Connect the sensor carefully and make sure that the polarity of connections, the operating voltage as well as the shape and duration of control

pulses are correct.

- Use only approved power supply units.

- Observing the permissible sensor limit values for operating voltage and environmental conditions etc. as specified in the product documenta-

tion is indispensable.

- Check and document the function of the position sensor regularly.

- Before activating the equipment, make sure that nobody's safety is impaired by starting machines.

Repairs

Repairs on the sensor may only be performed by MTS or a body that has been explicitly authorized by MTS.

Warranty

The MTS warranty period for the sensors and the accessories included in the scope of supplies in the event of material defects and faults oc-

curred although the intended use has been observed is 12 months from the reception of products. The MTS liability is limited to repair or re-

placement for every defective component of the unit. Warranty for defects due to incorrect use or excessive strain of the product as well as for

wear parts is excluded. MTS rejects any liability for consequences or side effects in case of violation of the warranty provisions**, independent

of whether warranty has been assured or expected. This is also applicable in the event of an error or negligence committed by the company.

MTS explicitly refrains from making any additional warranty promises. Representatives, agents, dealers and members of the personnel are not

authorized to increase or change the warranty conditions.

MH series sensors are designed to use on mobile machines or vehicles with a battery power supply (12/24VDC).

sensors by qualified personnel* or trained