Dover WILDEN BioPharm T2/SPPN/TF/TF/STF-903 Inżynieria, obsługa i konserwacja - Strona 11

Przeglądaj online lub pobierz pdf Inżynieria, obsługa i konserwacja dla Pompa wodna Dover WILDEN BioPharm T2/SPPN/TF/TF/STF-903. Dover WILDEN BioPharm T2/SPPN/TF/TF/STF-903 20 stron. Metal pumps

Drukuj stronę

Dover WILDEN BioPharm T2/SPPN/TF/TF/STF-903 Inżynieria, obsługa i konserwacja

SECTION 8A

MODEL T2 METAL

DIRECTIONS FOR DISASSEMBLY/REASSEMBLY

CAUTION: Before any maintenance or repair is attempted, the

compressed air line to the pump should be disconnected and

all air pressure allowed to bleed from the pump. Disconnect all

intake, discharge, and air lines. Drain the pump by turning it

upside down and allowing any fluid to flow into a suitable

container. Be aware of any hazardous effects of contact with

your process fluid.

The Wilden model T2 has a 25 mm (1") inlet and 19 mm ( ³⁄₄")

outlet and is designed for flows up to 95 lpm (25 gpm). The

single-piece center section, consisting of center block and air

chambers, is molded of polypropylene or aluminum. The air

valve is manufactured of brass or high-tech, engineered ther-

moplastics. All o-rings used in the pump are of a special mate-

rial and shore hardness that should only be replaced with

factory-supplied parts.

TOOLS REQUIRED:

Adjustable Wrench

⁄

" Box Wrench

1 6

⁄

" Box Wrench

Vise equipped with soft jaws (such as plywood, plastic

or other suitable material)

NOTE: The model used for these instructions incorporates

rubber diaphragms, balls, and seats. Models with Teflon

diaphragms, balls and seats are the same except where noted.

Step 2.

Utilizing the

⁄

" box wrench, start by removing the four long

1 6

carriage bolts that secure the top and bottom manifolds to the

center section. (Figure 2)

DISASSEMBLY:

Step 1.

Before starting disassembly, mark a line from each liquid cham-

ber to its corresponding air chamber. This line will assist in

proper alignment during reassembly. (Figure 1)

Figure 2

Step 3.

Remove the top manifold and lift the center section off the inlet

manifold. (Figure 3)

Figure 1

Figure 3

WILDEN PUMP & ENGINEERING, LLC