Comax CM-DW01 Instrukcja obsługi

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria Comax CM-DW01. Comax CM-DW01 2 stron. Wireless door/ window sensor

Drukuj stronę

Introduction

Thank you for choosing the COMAX's Wireless

for choosing the COMAX's Wireless Door/Window sensor. This sensor is a Z-Wave

is fully compatible with Z-Wave

Every main powered Z-Wave enabled device acts

Wave enabled device acts as a signal repeater and multiple devices result in more possible

transmission routes.

This sensor monitors door/window and send Z-Wave signal when door or window is opened and closed.

This sensor monitors door/window and send

Product Description and Specification

Specification:

Installation

1. Unscrew and open the rear cover.

2. Using the screws or adhesive tape fix the rear cover on the frame along the opening edge of door /

Using the screws or adhesive tape fix the rear cover on the frame along the opening edge of door /

window.

3. Insert a CR123A battery into the battery compartment and LED will start to flash slowly, which means the

Insert a CR123A battery into the battery compartment and LED will start to flash slowly, which means the

sensor has not yet been "added".

4. For adding sensor to a network, Put the Z

ng sensor to a network, Put the Z-Wave Interface Controller into "add" mode, and follow

add the CM-DW01 to your controller.

to your controller. The distance between sensor and controller is suggested to be in one

meter. Press the program switch of

meter. Press the program switch of CM-DW01 for 1 second. The LED on the sensor should go solid, if not,

please try again.

To remove the sensor from a network, Put the Z

To remove the sensor from a network, Put the Z-Wave Interface Controller into "delete" mode, and follow

instruction to delete the CM-DW01 from your controller. Press the program swit

6. Fix the Magnet by using the adhesive tape or fixing screws, locate the Magnet close to the

Fix the Magnet by using the adhesive tape or fixing screws, locate the Magnet close to the CM

distance between these two devices should be not more than 1.5cm.

distance between these two devices should be

Operation

1. Opening the door/window to separate the

Opening the door/window to separate the magnet from the sensor will send the status of "ON"

will flash once.

2. Closing the door/window to align the magnet with the sensor will send the

Closing the door/window to align the magnet with the sensor will send the status of "OFF"

flash once.

Normal operation, the LED will not light.

Operation Manual

Wireless Door/ Window Sensor

CM-DW01

as a signal repeater and multiple devices result in more possible

Protocol: Z-Wave

Wave

Frequency Range: 865.2 Mhz

Operating Range: Up to 50M

Operating Range: Up to 50M line of sight

Operating Temp.:

Operating Temp.: -10°C to 50°C

Battery: CR123A- 1Pc

Battery: CR123A

he distance between sensor and controller is suggested to be in one

from your controller. Press the program switch of sensor

signal when door or window is opened and closed.

add" mode, and follow instruction to

Wave enabled device and

should go solid, if not,

delete" mode, and follow

for 1 second.

CM-DW01 sensor the

he status of "ON" and the LED

status of "OFF" and the LED will