Amphenol Socapex RJSMLAC 8MG CAPS VAC Instrukcja obsługi sprzętu - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi sprzętu dla Router sieciowy Amphenol Socapex RJSMLAC 8MG CAPS VAC. Amphenol Socapex RJSMLAC 8MG CAPS VAC 15 stron. Ip67/68 rugged ethernet managed switch
Również dla Amphenol Socapex RJSMLAC 8MG CAPS VAC: Instrukcja obsługi sprzętu (14 strony)
Drukuj stronę
Section 3
Selecting a
Site
CAPS for
unused
connectors
Mounting
RJSMLAC 8MG CAPS UM rev. 3
Amphenol
– 948, Promenade de l'Arve – B.P. 29 – 74311 THYEZ Cedex – France - +33(0)4.50.89.28.00 – www.rjswitch.com
Installation
As with any electronic device, you should place the switch where it will not be subject to
extreme temperatures, humidity, or electromagnetic interference that exceeds the
RJSMLAC-8MG-CAPS
requirements:
•
The ambient temperature should be between -35 to 75 degrees Celsius.
•
The relative humidity is recommended to be less than 95% percent, non-
condensing.
•
Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards for MIL-STD-461E.
The switches are pre-equipped with caps on all ports, including power and Ethernet.
Make sure all connectors are protected with cap or sealed plug to ensure sealing
and prevent from deterioration of the contacts.
The RJSMLAC-8MG-CAPS Ethernet Switch can be fastened to any flat surface by mounting
the box directly. Refer to the mechanical drawings below. Make sure to allow enough room
to route your Ethernet and power cables.
The RJSMLAC-8MG-CAPS weights 1.8 Kg and is mounted via its four 4x4.5 mm holes for
screws.
The external dimensions of the RJSMLAC-8MG-CAPS are given here after.
's profile. Specifically, the site you select should meet the following
Page 5 of 14
Last Rev: 14-Dec-15