Amphony 2500 Instrukcja obsługi i instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Słuchawki Amphony 2500. Amphony 2500 12 stron. 5.8 ghz digital wireless headphones
Również dla Amphony 2500: Instrukcja obsługi i instalacji (13 strony), Porównanie funkcji (1 strony), Informacje o produkcie (4 strony), Często zadawane pytania (5 strony), Specyfikacje (4 strony), Instrukcja rozwiązywania problemów (5 strony)

User and Installation Guide

Step 4

Inserting the batteries into the headphones

After charging the batteries, insert them into the headphones.

There are two battery compartments, located on both sides, each housing one

battery. To access each battery compartment, push on the outer edge of the

battery lid. This will release the battery lid. Then lift the middle portion of the

battery lid to gain access to the battery compartment.

Insert the battery by pressing the minus pole of the battery against the spring at

the bottom of the battery compartment until the plus pole can slide into the battery

compartment. The battery should snap into place.

Ensure that the plus pole of the battery properly contacts the battery contact

inside the battery compartment to allow proper operation of the headphones. If

necessary, rotate the battery inside the battery compartment until proper contact

is established.

Finally, close the battery lid by pushing the middle section. It should snap into the

closed position.

To remove the batteries, open the battery lid as described above and pull the

battery out of the battery compartment by pushing the battery towards the bottom

until the plus pole is released and slides out.

ATTENTION!

Never leave any batteries inside the headphones for very long

periods of time to prevent any damage to the headphones from

leaking batteries.

Push

Lift

R R

Page 5