Dowco Fastrax 50145-00 Instrukcje instalacji

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Akcesoria motocyklowe Dowco Fastrax 50145-00. Dowco Fastrax 50145-00 2 stron. Backroads saddle bags

Drukuj stronę

WARNING

Please read and understand these instructions completely before installation to avoid possible injury to yourself or damage to

the accessory or vehicle. If you are unsure of your ability, seek the help of a qualified mechanic.

Over loading any Saddle Bag will result in a high center of gravity which will cause bike to be come top heavy and susceptible to

unexpected tipping, especially on lean-in, while negotiating high speed turns. Saddle bags must be loaded evenly side-to-side

maximum allowable load limit is 7lbs per bag.

Verify that straps do not obstruct exhaust system, turn signals, or tail lamp may result in injury or property damage.

1. Parts List:

This Product contains the following components. Before beginning installation confirm there are no missing or damaged compo-

nents.

Item #

Saddle Bag

Strap 29" long with (2) Hooks

Strap 20" long with (1) Hook

Strap 17" long with (1) Hook

Protective Strap Pads

2. Preparation:

Note: This product is supplied with a scratch resistant rubberized bottom layer. Care should be taken to avoid gas spills and heavy buildup of dust

and/or dirt under the bag; this may lead to scratches in the paint finish. Therefore the following preparation should take place before mounting the

luggage.

a. Place motorcycle on a secure, level surface

b. Clean all mounting surfaces before beginning installation.

3. Installation:

Note: This product is supplied with a number of different straps and strap lengths. Below are only a few suggested combinations to securely mount

to a motorcycle. You must choose which mounting system is best for your application.

Mounting Saddle Bag Only

a. Place saddlebag harness straps over or under seat/fender.

Loosen harness so the bags hang freely from fender without

tipping either to far outward or inward.

b. Locate front loop straps and secure around suitable frame

member. Connect to D-rings on front of saddlebag. (Fig. 4)

c. Position rear strap under license plate bracket or around

fender. An additional strap has been provided for bikes with

license plate brackets that are not readily accessible. (Fig. 3)

01073

INSTALLATION INSTRUCTIONS

BAG INSTALLATION: 50145-00

FASTRAX BACKROADS SADDLE BAGS

Description

Fig. 1

Qty

1 Set

EXHAUST PIPE

7/14