Advanced MxPro5 Podręcznik - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik dla Alarmy przeciwpożarowe Advanced MxPro5. Advanced MxPro5 10 stron.

2 Installation

Isolate ALL sources of power before installing or removing printed circuit boards.

Observe anti-static precautions at all times when handling printed circuit boards.

The printer is mounted onto the display plate in a pre-defined aperture.

ensuring that the connector on the PCB does not collide with the metalwork.

Push into position. Open up the paper roll aperture and then secure the printer mechanism using the two self-

tapping screws in the two holes either side of the printer paper roll recess.

Using a pair of strong side cutters, cut through the

1mm pips of the metal plate as shown below:

Pips

Using a sharp knife and working from the front

face, cut through the membrane label using the

outer edge of the aperture as a guide.

When the aperture plate is free, trim off and tidy

the edge of the label to the edge of the aperture.

Take care not to damage the fascia label.

Offer up the printer to the aperture and

guide the printer into position (at an angle)

To Base

Card

Printer

aperture