DOWINX LS-66LED Series Instrukcja montażu - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wyposażenie wnętrz DOWINX LS-66LED Series. DOWINX LS-66LED Series 7 stron.

Drukuj stronę

TABLE OF CONTENTS

Assembly④
Function Description
⚠

Safety Precautions

The precautions written here are to prevent harm or damage to you or others.
All of these are important contents for safe use, so be sure to observe them.
Ignoring this instruction and
⚠
using the product incorrectly
WARNING
may result in serious injury.
01
⚠
02
03
04
⚠
05
06
07
08
Care of Upholstery:
Gently scrub the surface with a soft brush, or
use a vacuum cleaner to remove dust from
09
seams and crevices.
If it gets dirty, just dab it with a soft cloth
dampened with a small amount of diluted
neutral detergent. Then, wipe off the cleaner
10
with a towel dampened with a little water.
⚠
ATTENTION
CAUSE OF SUFFOCATION
Do not cover your head with the plastic bag used for packaging.
CAUSE OF EXPLOSION
Do not disassemble or lubricate the gas cylinder.
Do not put the gas cylinder into fire.
Do not incinerate.
CAUSE OF FALL
Do not stand on the chair, use it as a stepping stone, or place it in an unstable
position.
Do not sit on the armrests or lean on the backrest, or sit on only part of the seat.
Do not use the chair on slippery floors.
CAUSE OF POISONING
Incineration may produce toxic gases.
CAUSE OF INJURY OR DAMAGE
Be sure to assemble on a stable, flat surface.
Be careful not to get your hands or fingers caught in the casters or reclining
parts.
When turning the chair, pay attention to your surroundings
Do not use it for anything other than its intended purpose.
CAUSE OF DISCOLORATION AND DEFORMATION
This product is for indoor or indoor use.
Outdoor use or getting wet may cause malfunction, rust or discoloration.
Avoid using the product in a place exposed to direct sunlight or heat such as a
stove, or in a place with significant humidity or dryness.
※In addition to the above, please be sure to avoid other dangerous behaviors.
Care of Metal and Resin Parts:
Wipe with a soft dry cloth. If it gets dirty,
wipe it with a diluted neutral detergent,
then wipe it with a wrung cloth, and then
wipe it with a dry cloth to completely
remove the detergent and water.
Ignoring this instruction and using
the product incorrectly may result
in injury or property damage.
US01