Down4Sound JP33 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Down4Sound JP33. Down4Sound JP33 8 stron.

READ!!!!!

Bluetooth Remote control working manual.

1. Power on : Pushing #5 potentiometer then, display dIS ( DISCONNECTION )

dIS is displayed before pairing or disconnecting the pairing.

2. Pairing

Pushing #2 for 2 ~ 3 seconds for pairing. Then, display SCN then, display volt as below

A er 10seconds of displaying volt then, go into sleep mode. Once touch #2 or #5 , then live again

[ SLEEP MODE is default -10 seconds display ]

PAIR LED ( Green ) is lit when it is paired. When If is o , try pair again.

3. ALL mode ( displaying LED is always on )

Pushing #5 for 3 seconds, then changed from Sleep mode to All mode by displaying ALL then, to display Volt.

When pushing #2 switch then, display change from Volt, ℉ and℃.

When turning #5, then display value of level for 10 seconds, then change to volt.

at All mode, Display is always on .

ALL mode consumes ba ery lot so when you use ALL mode, be er use C type connector

for power supply from car or check power status from portable power bank.

4. SLEEP mode ( Displaying 10 seconds then go into sleep mode )

At All mode, Pushing #5 for 3 seconds, then changed All mode to Sleep mode

When pushing #5, display SLP then, display volt then, sleep mode in 10 seconds.

5. Fahrenheit / Celsius display

On the display of voltage, push #2 one time, then display Fahrenheit for 10 seconds then, to sleep mode

On the display of voltage, push #2 twice , then display Celsius for 10 seconds then, to sleep mode

6. dIS ( Disconnection ) & Err ( Error ) display

On the display of dIS, try pairing again and move bluetooth remote control close to ampli er

On the display of Err, It is malfunction and try by replaving bluetooth remote control or Bluetooth module

in ampli er

7. link mode ( master /slave connection mode )

Due to Remote turn on / o fuction on BT remote control,

In Link mode, Bluetooth remote control at master ampli er works only. So please do not use Bluetooth remote control

for slave amp

In Link mode, Please connect REM from master ampli er to Slave amli er for REMOTE turn on / o feature.

so when Bluetooth remote control turns o remote then, master amp and slave amp both are o .

If master and slave amp REM is not connected each, Slave amp is not o even master amp

is REM turned o from BT remote control.

1) Master amp is power connected ( Slave should be disconnected ), then pair with Bluetooth remote.

2) Slave amp is power connected, REM is connected from master amp.

3) BT remote control master amp in link mode.

secret code: 1010100010010