CombiSteel 7072 Series Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zamrażarka CombiSteel 7072 Series. CombiSteel 7072 Series 9 stron.

CombiSteel 7072 Series Podręcznik użytkownika

Usage for the cooler

Temperature of the cooler is calibrated for the most proper conditions. The operating temperature can be
adjusted from the digital thermostat. We advise you to keep them with default factory value. Internal
temperature of the cooler is -20 / -22 degrees, can be adjusted 01 – 04 degrees. Digital thermostats have default
factory values, and no need adjustment. Thermostats may have many programs within (eco mode, night mode
etc.) If you have a problem with your cooler, please contact to service. Failure codes are listed in failure section.
If you get any of these, stop the alarm of the thermostat and inform the service.
There is no a private defrost process in your cooler. Although your products prevents snowing, high humidity and
temperature may cause snowing rate. Operating time depends on snowing, which also means energy
consumption will rise. At this position, stop the working and clean the snow.
DO NOT FORGET! UNFROZEN EVAPORATOR WILL GIVE THE HIGH EFFICIENCY.
Evaporator waters, stream to drip pan in compressor department. Although hot gas pipe evaporates this water,
checking and cleaning the pan is advised, at least for one time in a month.
For the 7072.0005-0010-0015-0020; The maximum loading distance is 48 cm.
Before calling service & cleaning
Before calling service
FAILURE
The cooler is not working
There is snowing or sweating in the
cabinet
Sweating at the glass
Temperature is high but it is not cooling
Internal cleaning
Remove beverages. Wait for the internal temperature that it will be same with environment temperature.
For cleaning and maintenance use a protection glove, this will protect you from injuries. Remove the accessories.
Use a soft cotton linen with warm soap water .For drying, use cotton based linen. For first operating, wait for
two hours. Than you can reload your beverages.
External cleaning
Use a cotton base linen with warm water. Avoid water from front control panel or lighting departments. For door
gasket, just use clean water with soap.
IMPORTANT!
Please do the loading by taking care of the loading line
Do not load above this height.
For the 7072.0030; loading should be from
5-6 cm height from the base up to 40 cm.
POSSIBLE SOLUTION
Check the plug and fuse.
The problem can be at electrical cable or plug.
Make sure the sliding lids are full closed.
Make sure that there is no air in the freezer.
External humidity may be increased or there is air in the freezer.
Please control the sliding lids.
Control the adjustment of the thermostat.
Make sure that air panels are not be closed.
9