CombiSteel 7489.4 Series Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kostkarka do lodu CombiSteel 7489.4 Series. CombiSteel 7489.4 Series 11 stron. Ice cube machines

Drukuj stronę

Cleaning and Maintenance of your Ice Maker

Safety rules required to be observed before cleaning your Ice Maker.

1. Cut off the power before cleaning the Ice Maker, unless otherwise specified in the cleaning instructions.

2. Never wash the outer casing of the product. This causes undesired electrical failures and jeopardizes the

safety of the user.

3. Always wear protective gloves and similar protective clothes before beginning cleaning.

4. Do not use cleaning agents and chemical substances which may cause cutting, piercing and corrosion during

cleaning. Otherwise, your ice maker will be out of warranty.

5. No cleaning agents not recommended by the Frozy brand should be used.

Outer Cleaning of the Ice Maker

The outer casing of the product is made by stainless steel. For this reason, wipe it with a cotton and

damp cloth or a sponge. Thereafter, dry it with a dry and cotton cloth.

Cleaning of the Ice Tank

Remove all the ices inside the ice reservoir. Wipe the inside surface of the reservoir with a soapy cloth.

Re-wipe with a clean wet cloth. Thereafter, dry with a dry cloth.

Take care not to allow any lime and cleaning solution residue to remain.

Cleaning of the Sprayer System

Make the water and electrical connection of the product in compliance with the instructions.

The power switch should be closed, and the water inlet valve should be opened.

Remove the wire located inside the pool and then remove the level discharge plastic from its slot, and ensure

the water to be discharged.

(See Figure 3)

Place the level discharge plastic back to its slot after discharging the water inside the pool.

(See Figure 4)

Set your product to the cleaning position.

(See Figure 5)

Then, pour the cleaning solution recommended by Frozy Authorize Service into the water pool.

Set the power button to the "Open" position.

The cleaning process will continue for 3 hours and 20 minutes.

Do not stop the product while cleaning is in process.

Thereafter, discharge the water inside the water pool. (See Figure 3)

Right after this cleaning, the Ice Set must be cleaned.

Cleaning of the Ice Set

Remove the top cover (See figure 6) and clean the cooling pipes and the visible surfaces on the reservoir with a

soapy cloth. Dry thereafter. Close the top cover of the product.

Cleaning of the Water Inlet Filter

Cut off the power of your ice maker. Cut off the water connection of your ice maker.

Remove the water inlet filter and maintain it. (Even though the cartridge replacement frequency depends on the

usage period, it is recommended to be replaced every 6 months.)

Apply the assembly instructions of the Ice Maker and make it functional.

Application contained in the cleaning instructions of the product should be performed at least 4-5 times in

year.