Advanced AS4000 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt bezpieczeństwa Advanced AS4000. Advanced AS4000 15 stron. Iron slider beam anchor

Inspection:

Official periodic inspection must be made at least annually. The inspection must be

a qualified person other than the intended user. If severe weather or conditions exist then

inspections must be carried out more frequently. All inspection results must be logged in the space

provided above. (It is recommended that the anchor device is marked with the date of the next or

last inspection.)

1. Make sure all labeling is affixed to the unit.

2. Inspect anchoring system for signs of damage or wear.

3. Make sure the ring is free to swivel and pivot.

4. Check for excessive play and wear on the retaining bushing

(Bushing should not wiggle or rotate.)

5. Insure latches engage and disengage properly.

6. Record inspection results in the space provide above.

*If any damage that could affect the strength or operation of the device, or unsafe conditions are

found, proper disposal is required. The anchorage connector must be rendered unusable and

then properly discarded.

fig 2-A

Make sure tags are attached

and legible with original

markings.

Compliance: OSHA 1926.502 & 1910.66 / ANSI Z359.1, ANSI Z359.7

CE 0321 / EN 795:1996 (+A1:2000) Class B

WARNING!!!

ALL PERSONS USING THIS EQUIPMENT MUST READ AND UNDERSTAND ALL

INSTRUCTIONS.

FAILURE TO DO SO MAY RESULTIN SERIOUS INJURY OR DEATH. USERS SHOULD BE FAMILIAR

WITH PERTINENT REGULATIONS GOVERNING THIS EQUIPMENT. ALL INDIVIDUALS WHO USE

Stainless Steel, Aluminum, Zinc Plated Steel, Bronze

Make sure rivets are void of

cracks and are fully seated,

flush with end piece.

performed by

Make sure Iron Slider bar is

free from burs and

deformation that would

impede the Iron Sliders

movement.