Follett C50R5A/W Instrukcja instalacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Dozownik wody Follett C50R5A/W. Follett C50R5A/W 13 stron. Ice and water dispenser
Również dla Follett C50R5A/W: Instrukcja obsługi, serwisu i części zamiennych (17 strony)
Drukuj stronęInstalling 25 and 50 Series wallhung dispensers
1. For all 25 and 50 Series wallhung dispensers, install supplied wall bracket
with six (6) 3/8" dia. fasteners as shown in diagrams below. (Note
that three holes are available at each fastening site to allow capture
of studs/support within wall.)
Steps 2 - 3 are required for Models H25T5A/W and H50T5A/W only.
2. For models with integral icemakers only (models H25T5A/W and
H50T5A/W), use straight edge to position filler strip flush with top
edge of wall bracket.
3. Fasten filler strip to wall as shown in drawings on page 7.
4. For all models, cut utility hole in wall using wall bracket as template.
5. Lift dispenser onto wall bracket, positioning unit such that hook on
back of dispenser is captured by wall bracket support angle.
Caution: Do NOT rest dispenser weight on
!
bottom front edge of wall bracket.
6. Install four (4) 1/4-20 screws through bottom of wall bracket into
bottom of dispenser to secure dispenser.
7. To gain access for final connections, remove access plate in bottom
of wall bracket.
Note: Electrical connection box can also be accessed through
front of dispenser by removing front cover, black plastic chute
cover and stainless splash panel.
8. If dispenser has remote icemaker and unit is equipped with water
station accessory, make water connection for water station inside
dispenser as indicated.
9. Proceed with instructions for installing remote or topmounted
icemaker as appropriate.
H25R5A/W mounting dimensions
support angle
9.5"
241 mm
Wall Bracket
9.5"
utility cutout
241 mm
3.40625" (87 mm)
11.4375"
4.59375"
125 mm
3/8"
Wall stud
fasteners (6 sites)
16"
406 mm
25.625"
651 mm
3.5"
89 mm
1.28125"
291 mm
33 mm
H25T5A/W
30.625"
77.8 cm
H50T5A/W
34.625"
88 cm
H25T5A/W
44.375"
112.71 cm
H50T5A/W
48.375"
122.9 cm
Side view and angle detail for wallhung units
with integral icemakers (in top of cabinet)
(Wallhung units with remote icemakers will not
require installation of a filler strip above support
angle and hook.)
H50R5A/W mounting dimensions
support angle
11.5"
292 mm
Wall Bracket
11.5"
utility cutout
292 mm
3.40625" (87 mm)
4.59375"
6
125 mm
ICDI220
Support angle and
hook detail
24.75
62.9 cm
17"
43.2 cm
19 3/8"
49.2 cm
Min. distance to
front of sink = 23"
(58.4 cm)
3/8"
Wall stud
fasteners (6 sites)
16"
406 mm
29.625"
752 mm
3.5"
89 mm
11.4375"
1.28125"
291 mm
33 mm
2.75"
7 cm
CL utility
entrance