AmpliVox AMP-W450 Proste instrukcje krok po kroku
Przeglądaj online lub pobierz pdf Proste instrukcje krok po kroku dla Wyposażenie wnętrz AmpliVox AMP-W450. AmpliVox AMP-W450 2 stron. Presidential plus lectern assembly featuring quickfit-expando 6 connectors
Drukuj stronę
Packing List:
Reading Table
Bottom Panel
2 Side Panels, left and right
Front-Dual Speaker Panel
Center Shelf
Black Speaker Grille [S/SW450]
Hand Held Microphone [S/SW450]
Microphone Cable [S/SW450]
Gooseneck [S/SW450]
Shock Mount Microphone Holder [S/SW450]
Amplifier [S450]
Wireless Amplifier [SW450]
figure 1
#10 x 3/4 PPH Screw
Plate Caster
[16 required]
Locking
[2 required]
Easy Step-By-Step Instructions for
W/S/SW-450 Presidential Plus Lectern Assembly
Featuring Quickfit-Expando 6 Connectors
The Presidential Plus Lectern is designed
for easy assembly. If you have any questions
about assembling or using your new sound
system, or if you want more information
about accessories, call AmpliVox's customer
service line.
1-800-267-5486
Hardware :
14 Quickfit-Expando 6 Connectors
[pre-installed]
14 Push-in Quickfit 6 Expanding
dowels
4 Minibloc Connectors[pre-installed]
8 Minibloc Screwpins
4 Plate Casters [2 Locking]
16 #10 x 3/4 PPH Screws
Tools Needed :
Phillips Screwdriver
POWER TOOLS ARE NOT
Use CAUTION during assembly
board edges can be sharp and
may chip if mishandled.
Remove staples from carton and
use carton to set parts on during
assembly.
ASSEMBLY INSTUCTIONS
1. Unpack all the pieces. Be sure
to save the packing and the box
in case you need to return the
lectern. Check that you have all
the pieces and that they are not
damaged. [figure 1]
2. Insert the steel pins. With your
thumb [use phillips screwdriver
to ease insertion], push the steel
pins into the holes in the two
sides. Make sure the plastic
collar is flush with the wood
surface. [figure 2]
Plate Caster
Quickfit-6
Nonlocking
Expanding Dowel
[2 required]
[14 required]
to minimize shipping damage. If your unit
was damaged in shipping call our toll-free
customer service line or visit our web site at
http://www.ampli.com
RECOMMENDED
NOTES ON ASSEMBLY
Quickfit-Expando 6
Connectors
[14 required]
Pre-inserted
The
lectern
is
carefully
3. Inspect the Quickfit-Expando 6
Connectors. The flat edge of the
connector must be facing the
outer
edge
of
Use phillips screwdriver to rotate,
if needed.
UNLOCKED
Edge of board
TURN COUNTERCLOCKWISE
TO UNLOCK
LOCKED
Edge of board
Quickfit-Expando Minibloc
Connectors
[4 required]
packed
the
board.
LOCKED
UNLOCKED
Minibloc Screwpins
[8 required]