Comdel ESC-2/FP Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przenośny generator Comdel ESC-2/FP. Comdel ESC-2/FP 17 stron. Electrostatic voltage source

Drukuj stronę
The WARNING heading used in this manual explains dangers that might result in personal injury or death.
Always read the associated information very carefully before performing the indicated procedure.
The CAUTION heading used in this manual explains hazards that could damage the unit. Such damage may
invalidate the warranty.
MUST – This word is understood to indicate a mandatory condition.
HIGH VOLTAGE – Voltages greater than 50 volts DC or 25volts AC and known to cause death or serious injury if
contacted.
SERVICE – Any operation of maintenance, repair, calibration or similar activity other than the normal operation of
the unit.
QUALIFIED SERVICE TECHNICIAN, QUALIFIED ELECTRICIAN, QUALIFIED PERSONEL These terms indicate
persons specifically trained to install, service or other wise handle electronic equipment of the character and hazard
potential of this unit.
End User Labeling
The system installer should obtain and apply all appropriate safety and warning labels required by the end user's
local fire department jurisdiction and Occupational Health and Safety Administration over and above those supplied
by the generator manufacturer.
Read And Understand This Section Fully Before Installing or Operating This Equipment.
WARNING: This equipment must be installed, operated and serviced only by trained, qualified persons.
General Safety Requirements
•
WARNING: Due to the presence of high voltages in and around the unit, extreme caution should be exercised
when using and handling this supply.
•
CAUTION: There are no user or operator serviceable parts inside this equipment. Refer all service to a
qualified service technician.
•
Do not operate the unit with the cover or end panels removed.
•
Never operate the ESC-2 with the output cables removed or disconnected.
3

Unpacking and Inspection

1.
Carefully unpack the unit and inspect for any obvious signs of physical damage that might have occurred
during shipment.
2.
Check the outside of the unit for missing or loose mounting screws or broken parts.
3.
If there is shipping damage or the unit fails to operate properly upon receipt, report damage to the carrier
immediately and notify Comdel factory within 30 days of receipt of unit. Failing to report any damage within
this time period is the same as acknowledging that the unit was received undamaged.
© 2006 Comdel, Inc.
ESC-2/FP Manual
2